AmorphousAlloy相关论文
The underlying structural origin of magnetic properties is still elusive in Fe-based amorphous alloys.In this study,dist......
The degradation of acid orange Ⅱ(AO Ⅱ)by a nanoporous Fe-Si-B(NP-FeSiB)electrode under the pulsed square-wave potentia......
Corrosion Resistance and Electrochemical Behaviour of Amorphous Ni84.9Cr7.4Si4.2Fe3.5 Alloy in Alkal
In this work,the corrosion behaviours of the amorphous Ni84.9Cr7.4Si4.2Fe3.5 alloy and its crystalline counterpart are s......
Preparation and Characterization of Amorphous W-B-C Alloy and Solid Solutions of C in Tungsten Borid
Mixtures of W and B13C2 powders were mechanically milled and subsequently annealed at 900-1200℃.It is found that amorph......
Effects of W Addition on the Electrochemical Behaviour and Passive Film Properties of Fe-Based Amorp
The electrochemical behaviour and passive film properties of Fe-Cr-Mo-W-C-B-Y amorphous alloys in acetic acid solution w......
Synergistic Effect of Mo, W, Mn and Cr on the Passivation Behavior of a Fe-Based Amorphous Alloy Coa
In this work,the electrochemical behaviors of SAM2X5 Fe-based amorphous alloy coating and hard chromium coating were com......
...
...
Cu-Zr-Al- (Y, Ag) amorphous alloy ribbons of Cu50Zr42Al8, Cu46Zr47-xAl7Yx (x=2, 5), Cu43Zr42Al8Ag7, and Cu43Zr42Al8Ag5Y2......
Amorphous metals are totally different from crystal metals in the array of atoms.The absence of grain boundaries, the we......
The outstanding corrosion resistance of FeCr alloys results from the presence of a thin oxide—passive—film on the meta......
...
Effect of ball milling on gas atomized Al88Ce8Fe4 alloy powders was investigated at charge ratios of 5∶1,15∶1 and 30∶......
利用功率为500 W的光纤激光器对晶态Ti47Cu38Zr7.5Fe2.5Sn2Si1Ag2合金基体进行了激光重熔实验,研究了不同工艺对熔池形貌及晶化的影......
The addition of a small amount of oxygen improves the mechanical properties,especially plasticity,of Ti45.7Zr33Ni3Cu5.8B......
In this work,amorphous Zr55Al10Ni5Cu30 alloy thin film was prepared on D36 steel substrate by magnetron sputtering metho......
Microstructure and mechanical properties of TC4 joints brazed with Ti-Zr-Cu-Sn amorphous filler allo
The Ti51.44Zr16.26Cu30Sn2.3(at%)amorphous filler alloy in a ribbon form was prepared by melt spinning.The Ti-6 Al-4 V al......
Influence of B,Al and Nb addition on the glass forming ability and stability of mechanically alloyed
我们调查了在在机械 alloying 期间形成能力(GFA ) 和 Zr-Ni 非结晶的合金的稳定性的玻璃上有代表性的原子尺寸的 B,艾尔和 Nb 的次......
Investigation of Fe-Ni-B and Fe-Cr-B Ultrafine AmorphousAlloy Powders Prepared by Chemical Reduction
InvestigationofFe-Ni-BandFe-Cr-BUltrafineAmorphousAlloyPowdersPreparedbyChemicalReductionGangBangwei;TanZhaosheng;YiGe;WangHa...
InvestigationofFe-Ni-BandFe-Cr-BUltrafineAmorphousAlloyPowdersPreparedbyChemicalReductionGangBangwei; TanZhaosheng;......
A new concept of lightweight structure,namely amorphous-alloy-reinforced perfo-rated armor(ARPA)consisting of the amorph......
综述了非晶合金催化剂(Ni-P、Ni-B)的制备、表征及其催化苯、硝基苯、烯烃等加氢反应性能研究。......
研究了Fe78B13Si9、(Fe0.99Mo0.01)78B13Si9非晶合金的激非晶化行为。激波是由氢-氧爆 生的。实验结果表明:激波能使非晶合金在微秒时间内晶化,晶化主相为α-Fe基固溶体,次......
本文主要对FeZrB系合金进行了制备工艺和组织等方面的研究。实验结果发现在FeZrB合金成分基础上降低fE含量添加Cu和Nb,可以明显改善......
本文以非晶态软磁合金作为敏感材料为对象,论述了脉冲感应型非晶态磁场传感器的研制。这种磁场传感器的工作原理建立在经典的电磁感......
对“FINEMET”(Fe73.5Cu1Ni3Si13.5B9)的设计原理作了分析和讨论。同时介绍了FINEMET在激波作用之下,其合金中最能体现其设计思想的Cu......
通过对Al80Cu20非晶的晶化过程的DSC分析以及粘度测试分析,并运用分子动力学模拟的方法,研究了液态Al80Cu20合金中存在的原子团簇......
本文应用升温、等温和重复加热的DSC技术,对FeSiB,FeMoSiB及FeCuNbSiB等几种非晶合金的激波晶化和退火晶化作了对比研究。结果表明,......
非晶态合金可用作催化新材料,本文用XPS方法表征了Ni-B和Ni-Co-B超细非晶态合金,并结合其对CO加氢的反应性能,初步解释了表面物种及状态与催化活性的关......
...
用磁天平(MB)及提拉样品磁强计(ESM)研究了(Fe1-xCox)84Zr3.5Nb3.5B8Cu1(x=0-0.8)非晶合金高温与低温磁性的变化,结果表明,该非晶态合金加热到80......